What We Offer

EVERYSERVICE.

Performed by trained hands using professional-grade products. No shortcuts. No exceptions.

Exterior Wash
45 min

Pressure rinse to remove loose dirt, pH-neutral foam bath, hand wash with microfibre mitts, and a final blow-dry. Streak-free, spot-free finish every time.

→ Pressure rinse
→ pH-neutral foam wash
→ Microfibre hand wash
→ Blow dry & wipe
Interior Clean
60 min

Full vacuum of seats, mats, and boot. Wipe-down of dash, console, and door cards. Glass cleaning inside. Odour-neutralising finish.

→ Full vacuum
→ Dashboard & console wipe
→ Interior glass clean
→ Odour neutralisation
Popular
Full Wash Combo
90 min

Exterior Wash and Interior Clean combined into a single visit. The most popular treatment. Leave with a car that feels factory-fresh inside and out.

→ Full exterior wash
→ Complete interior clean
→ Tyre dressing
→ Dashboard protectant
Paint Polish
3–4 hrs

Machine polish using professional-grade compound and finishing polish. Removes light swirl marks, water spots, and surface oxidation. Restores depth and gloss.

→ Clay bar decontamination
→ Compound polish
→ Finishing polish
→ Gloss sealant
Ceramic Coating
2 days

Professional 9H ceramic application. Two-stage paint decontamination, paint correction where needed, and a 48-hour cure. Long-term hydrophobic protection.

→ Paint decontamination
→ Two-stage correction
→ 9H ceramic application
→ 48-hour cure · 2-year protection
Engine Reboring
3–5 days

For high-mileage engines where cylinders have worn beyond tolerance. Cylinders are precision-bored, honed to specification, and fitted with oversized pistons and rings — restoring full compression and engine life.

→ Cylinder bore measurement & assessment
→ Precision reboring & honing
→ Oversized piston & ring fitment
→ Compression test post-rebuild
Seat Covers & Floor Mats
2–3 hrs

Custom-fit leatherette seat covers and 7D floor mats tailored to your vehicle model. Better than showroom accessories — professionally fitted, exact dimensions, with no gaps or loose ends.

→ Vehicle-specific leatherette seat covers
→ 7D custom-fit floor mats
→ Professional fitting & finishing
→ Full cabin coverage
Audio & Infotainment
3–6 hrs

Full car audio upgrade and infotainment installation — head unit, component speakers, subwoofer, amplifier, and wiring. Clean factory-level install with no exposed cables.

→ Head unit / Android display fitment
→ Component speaker installation
→ Subwoofer & amplifier wiring
→ Clean harness integration
Bumper Repair
1–3 hrs

Cracked, dented, or scraped bumpers repaired and refinished on-site. Plastic welding for cracks, filler for dents, and colour-matched spray paint — saves the cost of a full bumper replacement.

→ Crack assessment & plastic welding
→ Dent reshaping & filler work
→ Colour-matched spray paint
→ Polish & blend to original finish
Dent & Scratch Work
Assessed on-site

Panel beating, filler work, and colour-matched paint for dents, scrapes, and scratches. Assessed on-site — the repair disappears into the original finish.

→ Panel beating & shaping
→ Filler & surface prep
→ Colour-matched spray paint
→ Polish & blend finish
Headlight Restoration
45 min

Oxidised, yellowed headlights sanded back and polished clear. Restores light output and gives the front of your car a clean, sharp look.

→ Multi-stage wet sanding
→ Machine polish
→ UV sealant coat
→ Before & after check
Oil Change
30 min

Correct-grade engine oil, OEM-spec filter, and a full fluid top-up check. Done right, without shortcuts. We consult your vehicle manual — not guesswork.

→ Correct-grade engine oil
→ OEM-spec filter replacement
→ Fluid level check
→ Oil life reset
Engine Service
2–3 hrs

Complete engine health check — spark plugs, air filter, throttle body, belt condition, and cooling system. Identifies issues before they become breakdowns.

→ Spark plug inspection & replacement
→ Air & fuel filter service
→ Throttle body cleaning
→ Cooling system flush & refill
Battery Service
30 min

Full battery health diagnostic using a calibrated load tester. Voltage, cold cranking amps, and charge state checked. Replacement if needed, fitted and tested.

→ Load test & CCA measurement
→ Voltage & charge check
→ Terminal cleaning
→ Replacement & fitment if required
Brake Service
1–2 hrs

Front and rear brake pads measured for wear. Discs checked for scoring and run-out. Brake fluid tested for moisture content and replaced if needed.

→ Pad wear measurement
→ Disc & rotor inspection
→ Brake fluid moisture test
→ Pad & fluid replacement if due
Suspension & Steering
45 min

Full undercarriage inspection — shocks, struts, ball joints, tie rod ends, and bushings. Identifies the real cause of vibrations, pulling, or uneven tyre wear.

→ Shock & strut inspection
→ Ball joint & tie rod check
→ Bushing condition assessment
→ Steering play measurement
AC Service
1–2 hrs

Complete air conditioning service — refrigerant level check, compressor inspection, cabin filter replacement, and duct cleaning. Cool cabin, clean air.

→ Refrigerant check & recharge
→ Compressor & condenser inspection
→ Cabin air filter replacement
→ AC duct & evaporator cleaning
Wheel Alignment
45 min

4-wheel computerised alignment to manufacturer specification. Corrects pulling, uneven tyre wear, and steering drift. Protects tyres and improves fuel efficiency.

→ 4-wheel computerised alignment
→ Camber, caster & toe adjustment
→ Steering centre check
→ Test drive confirmation
Tyre Balancing
30 min

Dynamic balance of all four wheels using precision equipment. Eliminates steering wheel vibration at speed and prevents uneven tread wear.

→ Dynamic balance of all 4 wheels
→ Weight placement & verification
→ Valve stem check
→ Post-balance test drive
Tyre Rotation
20 min

Tyres rotated to the correct pattern for your drivetrain — cross, straight, or rearward. Extends tyre life and keeps wear even across all four corners.

→ Drivetrain-correct rotation pattern
→ Torque-spec re-fitment
→ Tread depth measurement
→ Tyre pressure set to spec
Fluid Service
30 min

Full check and top-up of all vehicle fluids: coolant, power steering, brake fluid, windscreen wash, and transmission. The kind of check most owners skip until something fails.

→ Coolant level & condition
→ Power steering fluid check
→ Brake fluid moisture test
→ Transmission & windscreen wash top-up
ECM Diagnostics
30–45 min

Full electronic control module scan using OBD-II diagnostic tools. Reads all fault codes across engine, transmission, ABS, and airbag systems. Clears codes after repair and confirms fix.

→ Full OBD-II fault code scan
→ Engine, ABS & airbag modules
→ Live data monitoring
→ Code clear & post-repair verification
Parts Sourcing
As required

Can't find the right part? We source OEM and quality aftermarket parts for all car makes and models. No running around — we handle the order, you bring the car when the part arrives.

→ OEM & quality aftermarket parts
→ All makes and models covered
→ Direct sourcing, no middleman markup
→ Fitment included on ordered parts
Not sure what you need?
Describe Your Issue

Tell us what your car is doing — strange noise, warning light, rough idle, anything. We'll diagnose it and tell you exactly what it needs.

All prices vary based on vehicle size and condition. Hatchback, sedan, SUV — we assess and quote before we begin. No surprises.